Pearson Yachts Forum

Pearson Boats - Common Systems => Electrical Systems & Electronics => Topic started by: jwspeck on May 01, 2016, 02:52:04 PM

Title: Any advice for cable pulling?
Post by: jwspeck on May 01, 2016, 02:52:04 PM

As part of the mast pull/step rebuild, I replaced the lights and added electronic instruments... new LED spreader lights, Steaming light, Anchor light, and a Maretron WSO100 wind meter.

Now I need to run some new wiring behind the starboard side salon... any advice for pulling the NMEA 2000 cable and additional power cables through that area?

Thanks,
John Speck
Lucky Mud
Hull #110

Title: Re: Any advice for cable pulling?
Post by: Dolce_Vita on May 03, 2016, 02:01:48 PM

The small overhead panels above the shelves next to the Nav station and behind the setee are removable and allow access to this area.  Cables can be fed in from the starboard sail locker area, up high and outboard.

Title: Re: Any advice for cable pulling?
Post by: selene on May 04, 2016, 01:04:35 AM

Okay, this may be a tangent...let's see if I can redeem myself in advance: 

My main wiring bundle is also on the starboard side, but access is by removing the backs of the settees. The bundle is inside that compartment suspended at the top. You have to take the nav desk out to complete the run, with the wires correctly secured (max 18" apart). Interestingly no wiring is behind the wooden panels Ed referred to; but our boats do differ in some specifics.

There is another run low down. A few wires in my boat follow the water pipes inboard of the starboard water tank at cabin sole level.

I am installing a new depth/speed transducer, and am not sure yet which route to pull the NMEA 2000 cable.

My other cable pulling challenge is this: I installed a Garmin wireless anemometer, but am considering moving to wired as I have had some trouble positioning the wireless receiver for optimal signal strength (latest test: in the head!), and not sure if I want to change the battery every 3 years.  But I am intimidated about pulling the wire down the mast.  How clear is that run? Any advice on running wires down the mast (while the mast is up - I don't want to pull it just for this!!)?

Slowly upgrading my electronics to the 21st century....so far very impressed with NMEA 2000 and Garmin kit.

Any random thoughts, observations or advice appreciated.

Title: Re: Any advice for cable pulling?
Post by: Bill1188 on May 04, 2016, 01:49:17 PM

My cables for instruments run through bilge, suspended, and then go to the port cockpit through the engine department. Easy access everywhere.